1. Saw machine maintenance Before operating the machine, the saw machine should also be checked to see if it is suitable for starting up. If there is a need to adjust the processing without processing, it may damage the machine tool or affect the processing quality at the beginning of the application. Let us talk about what aspects should be checked before the use of the sawing machine.

1. Check the direction of the cleaning brush, insist on the removal of tooth grooves and iron filings, and adjust or replace the cleaning brush if necessary. Check the height of the debris removal steel brush so that it just touches the bottom of the saw tooth. It should not be higher than the bottom of the sawtooth, which will cause excessive wear of the saw band or steel brush.

2. Check the gearbox and hydraulic tank oil gauge orientation, is it necessary to increase gear oil 150 #, hydraulic oil 32 #;

3. Check if the cooling water altimeter is increasing;

4. Check whether the orientation of the saw band on the active and passive wheels and tungsten steel guides is correct;

5. Check the saw band tension adjustment valve and select the proper sawing pressure; the maximum tension of the high-speed steel saw band is 55klbs / in2

6. Check the pressure of tungsten steel oil pressure gauge at 30 + 2kg / cm2;

7. Check the tension belt of the gear box;

8. Before installing the new saw band, shovel the iron scraps from the active and driven wheel flanges cleanly (iron scraps may accumulate).



Second, just like the car needs regular maintenance, the sawing machine needs to be maintained and replaced some parts after a period of use, so that the sawing machine can work normally.

1. The replacement of the steel brush can remove the iron scraps on the saw band, and can prevent the iron scraps from being brought into the saw wheel or even the saw band guide rail. If this will cause appropriate serious wear, the saw band Speaking of the main side. The steel brush of the fault device will cause excessive wear of the saw band or the steel brush, and will also cause instability during sawing.

2. Replacement of cooling water When the coolant is to be replaced under normal use, the iron filings in the cooling water storage tank must be cleaned and cleaned every three months.

3. Replacement of hydraulic oil The hydraulic oil should be replaced every six months.

4. Replacement of gear oil Gear oil must be replaced after six months or 1200 hours of use.

Taiwan Weiquan horizontal automatic band sawing machine