Note for sawing machine:

a. The same saw band should avoid too many lost interfaces. Weld at the same interface as much as possible. Before joining, the 3mm sides of the previous weld must be cut off.

b. According to the company's experience, the overwhelming factor of poor welding is unfamiliar with human operation, so the welding operation must be practiced frequently.

c. If the rocker cannot clamp the saw band during welding, loosen the fixing screw first, and then use a flat-blade screwdriver to rotate and adjust the mandrel to the clampable viewpoint.



Sawing machine welding:

a. Rotate the pressure adjustment knob.

b. The rotation direction is divided into 1 scale according to the pressure adjustment button of the saw band width every 2mm.

c. Press the fusion switch and press it to the bottom once. It takes about 3 ~ 6 seconds to shake your hand.

d. Turn the pressure adjustment knob to the zero position first.

e. Both ends of the saw band are smoothed, sealed, tightly connected, and rocker clamped.